1:25 wally tango build log (in progress)

This project aims to create a 1:25 Wally 100 Tango model: LOA=1219mm, beam=288mm Covid crisis and minimal ressources: a 28″ screen, openSCAD, some paper, two block of styrofoam, 3mm plywood… and a lot of “week-end” time. Choices made: composite hull because we are in the 21th century … and to keep the weight low fiberglass

Read More

Willow Sor build log

Willow Sor… and more precisely an E-Willow Sor. Straight forward build – nothing special except the electric conversion. The initial goal is reached: no lead added with the electric conversion so finally nearly no overweight compared to the non-electric model. This outrunner give me 90watt/lb which is pretty good and more than enough. redundant power

Read More

E-Schwing Corsa build log

This build is using the e-schwing fuselage to simply make an electric version of the Schwing glider (a Schwing Corsa here), not a hotliner as this fuselage was primary designed for. Finished with a pretty nice result: auw: 2380kg – and it is a Corsa 2.75m 😉 – the original e-schwing 88 was 2600kg in

Read More

Devuan / Debian cache with varnish

How to add a high performance devuan / debian / ubuntu / cpan repository cache (merged) with the security repo. Clean access paths: /devuan (merged devuan) /debian (debian) /debian-security (debian security) /ubuntu (ubuntu) /ubuntu-security (ubuntu security) /cpan (bonus) If none of these paths matches, varnish falls back to the local backend on port 8080. You

Read More

Huawei usb 3g modem reset – linux

A small memo to manage usb reset for Huawei usb 3g modem: Get a persistant udev device: Edit: /etc/udev/rules.d/99-usb-modem.rules SUBSYSTEM==”tty”, ATTRS{idVendor}==”12d1″, ATTRS{idProduct}==”1003″, SYMLINK+=”usbmodem” Reset the usb bus (quite rude but it is the only way i found to refresh the stack succesfully each time) and issue a ‘AT’ reset. #!/bin/sh # Reset USB bus for

Read More